1-3
I attempted to print a vessel shape that I designed back in 2017. Clearly a little overconfident. This part leans, and is asymmetric, which was not great for a first test.
These first three tests were run to about 50% but all were “failures”
Printing at 4 bar, spiral single-wall
While these look terrible and have lots of air bubbles present, disrupting the surface, they were the first prints to build any clay at all, so they are saved here for posterity.




4-5
Again try same shape, but even worse, failing within 10% (10mm)
Printing at 3.5 bar, not enough pressure